To get the latest information on sales and new images join our email list
Adhesives & Tapes
Stamp Pots onto a piece of copper sheet metal using Stazon ink. Let dry then trace over lines with a stylus. Turn piece over and push out areas around the embossed lines. After you emboss the copper, heat the piece with a heat gun for several minutes to change the color of the copper. Roll the tracing wheel over the edges and trim to 5 ¼” x 2”. Trim corners of a 6” x 2 ¾” piece of black c/s using corner scissors. Attach this to a 6 ¼” x 3” piece of kraft c/s which also has corners trimmed. Attach copper brads at top and bottom as shown.
a 6 ½” x 5” piece of red confetti c/s using a stylus and texture plate. Rub over
the raised areas with copper ink pad and edge with copper leafing pen. Place
paper weaving stencil along right edge, trace lines and cut with a craft knife.
Thread short lengths of ribbon through the cut slits as shown. Attach black
layered c/s to left side of front then attach to a 6 ½” x 5” card front. Attach
copper piece on top of black layered piece with red liner tape. Thread a scrap
piece of the copper through the concho and attach as shown using red liner tape
and foam pop dots.